Jia Han

Do you use dies for stamping metal springs

Release Time：

2022-07-28 11:14

Source:

来源

Do you press metal springs with a die 
1.For metal spring stamping die, the size and shape of compact metal stamping parts will not damage the appearance quality of metal spring stamping parts and the service life of the die as usual, so the stamping parts have stable quality and good interchangeability.

2.Metal spring stamping has no natural debris, less material loss, and does not need other heating and shaping equipment. It is a stamping part with material saving, energy saving and low cost 
The processing scale of metal spring stamping parts is large. Large-shaped parts, such as small clock stopwatches, automobile longitudinal beams and panels, combined with the cold deformation and hardening of stamping materials, have great strength and stiffness when stamping
3.Metal spring stamping has high production efficiency, convenient operation and easy realization of mechanization and automation. This is because stamping dies and stamping equipment depend on the punishment of disposal. Usually, the number of strokes per minute can reach dozens, and the high pressure per minute can reach hundreds or even thousands. Approximately one stamping can be obtained per stamping stroke

Previous Page

Introduction to blank holder of metal stamping die

Knowledge of processing metal stamping parts

Next Page

Hot News

Four common stamping processes for metal stamping parts

Metal stamping is a kind of processing method with high production efficiency, less material loss and lower processing cost.

Metal stamping - which parts are the main sections of blanking parts

The section of blanking parts can be divided into four distinct parts: Collapse corner, smooth surface (bright zone), rough surface (fracture zone) and burr

Introduction to blank holder of metal stamping die

The blank holder of metal stamping die is mainly a pressing device designed to prevent stamping and drawing products from wrinkling in the drawing process.

Do you use dies for stamping metal springs

Do you press metal springs with a die  1.For metal spring stamping die, the size and shape of compact metal stamping parts will not damage the appearance quality of metal spring stamping parts and the service life of the die as usual, so the stamping parts have stable quality and good interchangeability.