Jia Han

Four common stamping processes for metal stamping parts

Release Time：

2022-11-18 11:50

Source:

Metal stamping is a kind of processing method with high production efficiency, less material loss and lower processing cost.


It is more suitable for mass production of parts, easy to realize mechanization and automation, has higher precision, and is convenient for post-processing of parts


For general metal stamping parts, in the production process, there are the following four processing processes

Blanking: Stamping process in which sheet metal are separated (including punching, blanking, trimming, cutting, etc.).


2.Bending: Stamping process in which sheet metal is bent to a certain angle and shape along the bending line


3.Drawing: Stamping process in which flat sheet materials are changed into various open hollow parts, or the shape and size of hollow parts are further changed.


4.Local forming: Stamping process (including flanging, bulging, leveling and shaping, etc.) in which the shape of a blank or stamping part is changed by local deformation of various properties.


Ruishuo Hardware has been focusing on metal stamping parts for 15 years, with more than 20,000 sets of customized production experience, monthly processing capacity of more than 100 sets of dies, daily production capacity of 3 million punches, stamping accuracy of 0.01mm, and 16 strict quality control processes


It can quickly solve the urgent problem of metal stamping parts, stamping accuracy and production quality for you. Choose Ruishuo to get rest assured

Previous Page

None

Metal stamping - which parts are the main sections of blanking parts

Next Page

Hot News

Four common stamping processes for metal stamping parts

Metal stamping is a kind of processing method with high production efficiency, less material loss and lower processing cost.

Metal stamping - which parts are the main sections of blanking parts

The section of blanking parts can be divided into four distinct parts: Collapse corner, smooth surface (bright zone), rough surface (fracture zone) and burr

Introduction to blank holder of metal stamping die

The blank holder of metal stamping die is mainly a pressing device designed to prevent stamping and drawing products from wrinkling in the drawing process.

Do you use dies for stamping metal springs

Do you press metal springs with a die  1.For metal spring stamping die, the size and shape of compact metal stamping parts will not damage the appearance quality of metal spring stamping parts and the service life of the die as usual, so the stamping parts have stable quality and good interchangeability.